How to Bore for a New Door Knob

Steps:

1. Place the hole saw jig on the door. Position it three feet off the ground. Set the backset measurement to either 2 3/8” or 2 ¾”, depending on the style of the door and personal preference.
2. Use a drill/driver with the 2 1/8” hole saw to bore a hole through the door. Once the center bit is through the door, stop. Bring the hole saw the other side of the door and finish the bore.
3. Use the 1” hole saw to bore a hole through the edge of the door to create an area for the latch.
4. To make room for the latch plate, place the latch plate on the edge of the door and draw an outline. Use a chisel to remove the wood inside the outline. Seat the latch plate into the edge to make sure it fits properly.
5. With the latch plate seated, install it using screws and a screwdriver.
6. Install the door knobs to the front and the back of the door. Line up both pieces and attach them through the latch. Use screws and a screwdriver to fix them in place.
7. If necessary, mortise out the jamb for the striker plate. Outline the plate and line it up with the striker. Use a chisel to mortise the outline.
8. Use screws and a screwdriver to attach the striker plate.